AMETEK, Inc. is a leading global manufacturer of electronic instruments and electromechanical devices. AMETEK has over 15,000 employees at 150+ manufacturing locations around the world. The company, with 12 divisions and business units, serves the Aerospace and Defense, Connectors, Metals and Engineered System & Materials, Electronic Instruments, Motors and Blowers, and Power markets.
AMETEK was contracted by Lockheed Martin to design a portable flight suit chiller unit for the Joint Strike Fighter (JSF) program. This system works with a pilot cooling vest to maintain a pilot’s deep body core temperature at ≤ 100.4° F (38° C). The JSF program aims to deliver affordable, next-generation striker aircraft weapon systems for the U.S. Navy, Air Force, Marines and allies. Pilots flying these aircrafts are subject to high levels of acceleration – up to 9g – and must wear G-suits to prevent blackouts. To prevent pilots suffering from heat stress in the cockpit and on the ground, portable flight suit chiller units are needed.
Embed in the Development Process
The individual cooling equipment (ICE) has four components: a charger, a Li-ion battery, a battery,
and a fluid charger. The Personal Cooling Unit (PCU) interfaces with the cooling vest and delivers the cooling fluid. It uses a vapor cycle cooling circuit and receives fluid from the cooling vest, which transfers the heat load extracted from the pilot. The system has multiple control loops. One regulates the fluid-out temperature and the compressor speed to achieve a specific temperature setting. Another monitors the temperature difference over the evaporator and controls the refrigerant flow. Part of the design challenge is monitoring the multiple variables and developing the code that goes to the controlling device to make those adjustments automatically. The chiller unit must also run within its power limits to prevent damage.
Working under a tight schedule, Godfrey and his team decided to follow a model-based development (MBD) approach - leveraging Embed.
Using Embed, the team created a working model of the combined chiller unit and control system via a block diagram approach. They correlated and refined the plant model using measurements of plant responses in the lab. Then a multi-loop PID controller was built with interlock safety stages that stepped through the start-up and shutdown actions necessary to avoid damage to sensitive device components.
After debugging and tuning the controller in offline Embed simulations, an ANSI C code from the controller model was created automatically. Then the code was compiled and downloaded directly to the Texas Instruments (TI) C2000 target chip, using a bi-directional Joint Test Action Group (JTAG) link. Engineers tested the control algorithm firmware running on the C2000. It resides in the Embed plant model running in real time on a PC, using JTAG technology to easily provide an interface between virtual plant outputs supplied to the firmware and firmware control outputs supplied back to the virtual plant model in Embed.
When engineers were satisfied with the embedded controller’s behavior, they replaced the interactive JTAG input/output (I/O) ports with Embed blocks for analog-to-digital converter input, general-purpose I/O, pulse-width-modulated (PWM) outputs and custom hardware sensors.
They generated ANSI C code from the controller model, downloaded it to the TI target and ran it against the Embed model in real time. At this point the controller was electrically connected to the Embed virtual plant. This implemented “hardware-in-the-loop” (HIL) testing.